|
|
A-3000 KT88 Mono Power Amplifiers
$12,900
140wpc Stunning newly designed chassis now in stock. Please call to audition in your system.
The M-3000 monoblocks are Allnic Audio’s top of the line, parallel push-pull power amplifier model. Like all Allnic Audio products, the M-3000 has Permalloy (iron and nickel alloy) for its transformer cores.
Features
•140 watts of high power output. The M-3000 is a parallel push-pull, triode/pentode switchable power amplifier.
•Powerful Driving Circuitry. Allnic believes in the importance of using high-quality, low noise and powerful driving circuitry in all its amplifying devices.
•“Full Engagement" Output Transformers.
Allnic's "Full Engagement" transformers have 4 independent, secondary windings which are always fully connected, never "idled". This means that all secondary windings are always connected to your loudspeakers, regardless of which output switch position you use (4 ohms or 8 ohms or 8 ohms or 16 ohms, depending on the factory configuration you have selected). The result is that there is neither a loss of transformer output efficiency, nor the introduction into the output signal of distortion from parasitic oscillations of the secondary windings.
•Large Nickel/FeSi Core Output Transformers. As with our other models, Allnic uses very large output transformers (114 mm) with nickel, mixed with FeSi, cores. This provides for higher inductance with fewer windings than other designs can provide and results in the great benefit of an extremely wide range of output frequencies.
•"Soft-start" Circuitry. Allnic uses soft start circuitry that, after sufficient warm-up only, provides the high voltage supply to the plate of each tube. This protective design results in prolonged tube life and fewer and less frequent issues with tube performance.
•Analogue Power Tube Current Monitors. In order to provide constant current (bias) monitoring for the power tubes, Allnic uses a separate analogue current meter for each tube. The meters make it exceptionally easy to see the status of each tube at any time and to respond immediately to any variation in bias by use of the bias control knob for the relevant tube. The meters offer a simple, unambiguous indication of each tube's status compared to conventional LED bias monitors.
•"On-the-Fly" Triode/Pentode Switching. Switching between triode and pentode operation can be done "on-the-fly" at any time while the amplifier is in use.
•Beautiful 20KHz square wave response.
|
|
  |
A-6000 300b Mono Power Amplifiers
$17,900
World's most powerful SET 300b amplifiers.
50 watts of pure class A high power output.
The A-6000 is a double parallel single ended power amplifier.
Real power drive.
Our choke inductor (100% nickel permalloy PC core) has very low power loss and infinitely
high load impedance. The driver tube 6GV8 has strong power pentode, we use this power pentode to drive the 300B via choke plate inductor. This is one of the ideal drive stages for a 300B SE amplifier.
Nickel alloy output transformer.
Long life and trouble-free operation. Allnic employs a “soft start circuit” to protect the tubes and other parts.
Fixed bias control grid. Allnic prefers to use low distortion and high output “fixed bias” rather than the relatively higher distortion and lower output “self bias” method.
Natural negative feedback. The A-6000 has a relatively high “damping factor', very low distortion, and a higher S/N ratio, without losing the signature of single ended natural sound quality.
The A-6000 is all hard wired.
Custom 300b tube choices are available.
Manual and Specs in pdf |
|
|
A-5000-NEO Power Amplifier
$10,900
25 watts of pure class A high power output.
Real power drive.
Our choke inductor (100% nickel permalloy PC core) has very low power loss and infinitely
high load impedance. The driver tube 6GV8 has strong power pentode, we use this power
pentode to drive 300B via choke plate inductor. This is one of the ideal drive stages
for 300B SE.
Nickel alloy output transformer.
We use a sophisticated ratio mixed nickel permalloy PB cored output transformers.
Due to its extremely high initial permeability, it allows us lower turns of primary winding with still higher open circuit inductance, which means very wide frequency
range and low distorted bass response.
Long life and trouble-free operation.
We employ the
“soft start circuit” to protect the tubes and other parts. It applies the high B+ voltage only after tubes are fully warmed up.
Fixed bias control grid.
Natural negative feedback
The A-5000 NEO is all hard wired.
Manual and Specs in pdf
|
|
  |
L-3000 line stage
$10,900
The L-3000 is Allnic Audio’s reference line stage preamplifier.
Features
Single gain stage
Single gain stage circuit uses only 'one' tube in amplification, which reproduces
purer, more detailed, more spacious and more dynamic sound than multi gain stages.
Line output transformer coupling
Constant and low output impedance
No negative feedback design
Advanced tube technology voltage regulation
Allnic Audio’s patented "Absorb GEL tube damper" technology
Precision attenuator volume control
Pure Class A operation
Pure balanced operation
Two Balanced inputs
Three RCA inputs
Manual and Specs in pdf
|
|
  |
L-1500 line stage
$5,700
Exceptional value in a premiere line stage.
Features
Single gain stage
Line output transformer coupling
Constant and low output impedance
Advanced tube technology voltage regulation
New vacuum tube damping technology
Precision attenuator volume control
Pure Class A operation
Manual and Specs in pdf
|
|
  |
H-3000 Phono Stage
$11,900
Reference Phono Stage featuring convenient gain and cartridge loading via knobs on top of chassis
Allnic Audio’s top of the line phono stage model.
The H-3000 Phono Stage is all transformer coupled.
No negative feedback design with only two gain stages
For superior signal to noise ratios, the H-3000 is equipped with pure vacuum tube, high speed, automatic voltage regulation for each channel and a power supply unit separate from the phono stage itself.
High quality MC Step-up Transformers with Permalloy cores are used for the H-3000’s dual MC inputs.
New vacuum tube damping technology – Allnic Audio’s patented "Absorb GEL tube damper" technology prevents harmful vibrations from reaching the signal / gain tubes and, therefore, prevents micro-phonic noise propagation in the tubes.
Pure Class A operation
Pure balanced operation
Manual and Specs in pdf |
|
  |
H-1500 II SE Plus
$5,600
The H-1500 II PLUS is Allnic Audio’s outstanding value phono stage.
Features
LCR TYPE RIAA EQUALIZATION
LCR filters
Four gain transformers are employed.
For superior signal to noise ratios, the H-1500 II PLUS is equipped with pure vacuum tube, high voltage regulation for each channel and a power supply unit separate from the phono stage itself.
High quality MC Step-up Transformers with Permalloy cores are used for the H-1500 II PLUS’s dual MC inputs.
New vacuum tube damping technology
Pure Class A operation
Manual and Specs in pdf
|
|
 |
HA-3000
$4,900
Two piece M/C step up transformer with Nuvistor technology. Careful system matching required. A magical window into the music for the advanced listener. Resistor control adjustable from the front panal to 50, 100, 200 and 500 ohm choices. RCA in and out. Nuvistor tubes last approx 100,000 hours. Call for more information. Black units available approximately January 30th, 2010. Reserve yours now or purchase silver for quickest delivery. |
|
  |
AUT-2000
$1,600
Custom nickel wound transformer system that competes with the best
Four position gain, same transformer as in the H-3000 Reference phono stage.
Manual and Specs in pdf
|
|
 |
Absorb-GEL Socket inserts
$125. pr for nine pin tubes
$125. pr for eight pin tubes
Microphonics describes the phenomenon where certain components in electronic devices transform mechanical vibrations into an undesired electrical signal (noise).
Here is a very effective solution to eliminate microphonics in small signal tubes. No hard wiring, just insert into you socket. Sold in pairs only. Please allow 1-3 weeks for delivery.
|
|
 |
VERITO Z Allnic provides the very best customer service.
$2,800
Every LP record master is engraved using an LP cutting lathe's cutter head. Unlike other cartridges, the Verito “Z” moving coil cartridge is designed to reproduce music via a mechanism that emulates the LP cutting lathe's cutter head.
Satisfying in its detail and sound stage, with a "see into the music" character.
Manual and Specs in pdf |
|
 |
Puritas
$4,900
Allnic's Newest cartridge takes on all comers! CNC machined Ebony headshell. Watch for shoot outs between Paritus and the best know cartridges in the world. Limited availability, please call. |
| |
|